Analysis of Automation Processes of Printed Circuit Boards Manufacturing Equipment

Authors

  • Marko Klepach NUWM
  • Mykola Klepach, National University of Water and Environmental Engineering image/svg+xml , National University of Water and Environmental Engineering image/svg+xml
  • Leonid Kozak National University of Water and Environmental Engineering image/svg+xml , National University of Water and Environmental Engineering image/svg+xml

DOI:

https://doi.org/10.31713/MCIT.2019.36

Keywords:

automation; simulation model; PID controller; optimization; movement control

Abstract

In this article, the authors present a process of the printed circuit boards manufacturing equipment simulation model design. The model was used to create, optimize and test the movement control subsystem of the device.

References

Downloads

Published

2019-11-05

Issue

2019: Modeling, control and information technologies: Proceedings of III International scientific and practical conference

Section

Problems of automated control, optimization and parameters identification

How to Cite

Analysis of Automation Processes of Printed Circuit Boards Manufacturing Equipment. (2019). MCIT: Proceedings of International Scientific and Practical Conference, 3, 110-111. https://doi.org/10.31713/MCIT.2019.36

Most read articles by the same author(s)